Epoxy reike with fast drying time and good transparency, ideal for pouring into silicone molds. Professional product specially designed for jewellery processing and artistic creation. The epoxy recycle developed gives better transparency, strength and shine, but much shorter hardening
time as traditional resins.
The cast of the mold can be extracted from the silicone mold
take after 6 hours, but achieves maximum strength (not deformed) after 24-48 hours.
iCreation
17.20 € – 38.70 €
Description
Catalysis, or drying time, is also influenced by external factors, such as temperature. The higher it is
temperature, the faster the hardening occurs. But you can't get too hot, because then
may dry the epoxy hard during drying.
As with all other epoxy relics, iCreation can use all colors and toners for epoxy. But it should be kept in mind that the share of paint in volume does not exceed 1%, because otherwise the finished epoxy rein may not reach the desired strength.
Given the rapid catalysis rate of this product, pain 10 mm thick or even thicker must be taken into account
in case of quiet heating up quite a lot. Therefore, the resin should not be touched for up to 2 hours after pouring into the mold. If it is necessary to pour a thicker layer, we recommend Liquidissier (up to 30mm) or transparent epoxy reiku Transparente (up to 20mm).
TECHNICAL CHARACTERISTICS:
Mixing ratio by weight 100:50
The workability time is 10′-15' min for volumes up to 30 g
We recommend mixing carefully for 60-90 seconds
Prepare max. 100g of product at a time to prevent premature hardening of resin
Additional information
Weight | - |
---|---|
Net bom weight | 1.5 kg, 300 g, 750 g |