Poli Shield

POLI SHIELD is the ultimate protective layer that generally protects your floors and surfaces from scratches and wear. The product is applied to the surface with a roller or sprayer on any type of floor. Especially suitable for resin floors (epoxy, acrylic). POLI SHIED is designed to complete the M1-723 cycle to ensure aesthetic, easy-to-wash and durable finishes on surfaces. The product is shiny.

ADVANTAGES:

Durable and wear-resistant: Special acrylic polyurethane polymers combine the stability and simplicity of acrylic resins and the scratching and wear resistance of the most advanced polyurethane polymers.

Easy application: The product is applied with a short-haired roller, foam roller or sprayer. Tools can be cleaned simply with soap and water. The two-component set is ready for use.

Versatile and elegant: POLI-SHIELD is available in a variety of finishes: glossy (100 glosses), satin (30 glosses) and matte (with 5 glosses). It is suitable for a wide variety of surfaces: epoxy, acrylic, wood and concrete, and textured finish. At the moment, only a glossy product is available.

Easy to maintain: The surface treated with POLI-SHIELD becomes easy to clean with soap, eliminating absorbed dirt and spread bacteria. If necessary, floors under increased load can be re-covered with a roller in worn areas to restore and make the floor shine again as on the first day!

Cheap: with one set (2.4 liters) covers up to 25m2 (with a double layer).

Are you looking for a cheap, efficient and easy-to-implement solution to protect and upgrade your floors and surfaces in general? POLI-SHIELD is a product for you!

Preparation:
• Combine the contents of POLISHIELD A with this hardener according to the instructions on the package (100A + 20B).
• Mix mechanically, making sure that the two components are perfectly mixed. Hand mixing alone may not be enough to achieve a perfect result. We recommend stirring for at least 3 minutes.
• Catalysis ratio must be by weight (100A+20B), not by volume, use electronic weight.
• Apply the first layer of POLI-SHIELD with a shorthair roller, brush or airless sprayer and leave to dry for 4-6 hours.
• Apply the second layer of POLI-SHIELD with a smooth roller, brush or airless sprayer.
• In the POLI-SHIELD 100Gloss version, a third layer can be applied to increase surface gloss and homogeneity.
• The cycle is over and you can walk on your floor after 24-48 hours, depending on the ambient temperature.
IMPORTANT:
If more than 24 hours remain between the layers, grind with 320 hardness paper.
Maximum scratch resistance is achieved about 7 days after hardening.